2.5.3
Hard Disk Drive (HDD) Installation
The hard disk drive bracket plate is accessible by removing the bottom panel.
To access, remove the two (2) screws securing the bottom panel to the chassis, and
then lift the panel off, as shown below.
1
3
2
Remove the baseplate, then place the HDD on the bracket plate, then insert and
tighten the four (4) screws to secure the HDD to the bracket plate. Lastly, secure the
structure to the bottom panel by inserting and tightening the outermost four (4)
screws, as above.
Chapter 2 – Hardware Information
37