Table of Contents
Advertisement
en
Installation
5Installation
P reparing the installation
I n s t a l l a t i o n
Caution!
Ensure that there are no electrical wires, gas pipes or
water pipes in the area where holes are to be drilled.
Mark a vertical centre line on the wall from the
1.
ceiling to the lower edge of the extractor hood.
Use the enclosed template to mark the positions for
2.
the screws and the outline of the attachment area.
Drill five 8 mm diameter holes to a depth of 80 mm
3.
for fastening the appliance and press in the wall
plugs flush with the wall.
14
Installation
Screw on the fixing bracket for the flue duct.
1.
Screw on brackets for the extractor hood hand-tight.
2.
Do not firmly tighten the screws.
Screw in the threaded bolt, leaving it protruding out
3.
of the wall by 5–9 mm.
¨
©
ª
Advertisement
Table of Contents
