Table of Contents
Advertisement
Troubleshooting ––
Problem
Does not operate.
Even after
recharging, within
a short time the
unit cannot be
used.
Does not operate.
24
Problem? Malfunction?
If problems arise, first try these suggestions before having the
unit serviced.
Possible Cause
• POWER is not turned ON.
• When POWER is turned ON,
the display window stays fixed
on the display
.
• The display window stays fixed
on a number display such as
.
• The display window stays fixed
on the error display
• The internal battery pack has
not been recharged.
• The battery pack is about 2
years old and should be
replaced.
• POWER is not turned ON.
• Master/Slave switch is not
switched to "M" master.
• Auto/Point switch is not set
properly.
• Address number is not
properly set.
• The exhibit card is covering the
optical transmission lens.
Solution
• Turn POWER switch to ON.
• There is a problem with the
internal program of the main
unit.
Contact a JVC service
representative.
• Take out the CF card and insert
again.
If this does not resolve the
problem, contact a JVC service
representative.
• The CF card has malfunctioned.
Replace with a CF card that
.
functions properly.
• Recharge the Portable ROM
Player with the recommended
chager.
• Purchase a new battery pack
(BN-R368) at your local dealer.
• Plug the power adaptor into a
power outlet.
• Switch to "M" master.
• When using the Pointing
method:
set the switch to
"P" point.
A
P
• When using the Auto method:
set the switch to
"A" Auto.
A
P
• Set the correct 3 digit address
number using the Address
Rotary switch.
• Place the card so that the
optical transmission lens is
visible.
Reference
page
page 17
¶
¶
¶
page 7
page 23
page 8
page 8
M
S
page 8
page 8
page 10
Advertisement
Table of Contents
