Hitachi GR4000 Series Installation Manual page 117

WARNING: DO NOT BLOCK THE VENTILATION SLOTS. IF YOU BLOCK THE
WARNING: WHEN INSTALLING THE GR4000 OR GS4000 ON A DESK, LAY IT DOWN
WARNING: WHEN INSTALLING THE GR4000 OR GS4000 ON A DESK, LAY IT DOWN
!
*
520-10-014-20X
VENTILATION SLOTS, THE INSIDE OF THE DEVICE WILL OVERHEAT AND
COULD CAUSE A FIRE. RESERVE AT LEAST 70 MM OF SPACE FROM THE
VENTILATION SLOTS OF EACH DEVICE TO ENSURE PROPER AIR FLOW
THROUGH THE VENTILATION SLOTS.
HORIZONTALLY IN IT'S NORMAL ORIENTATION. IF YOU STAND IT
VERTICALLY OR LEAN IT AGAINST A WALL, IT COULD FALL AND BE
DAMAGED AND POTENTIALLY CAUSE INJURY.
HORIZONTALLY IN IT'S NORMAL ORIENTATION. IF YOU STAND IT
VERTICALLY OR LEAN IT AGAINST A WALL, IT COULD FALL AND BE
DAMAGED AND POTENTIALLY CAUSE INJURY.
Caution: When carrying or packing the device and its optional units, wear a wrist strap
to prevent static electricity. Without a wrist strap, the device might be damaged
by static electricity.
NOTE: Place the GR4000 in a position where you can easily check the condition of the
front panel indicators.
- Protect cables by running them through a duct or by using a braid. Especially
for optical fiber cables, a cord bend radius of at least 100 mm in length and 50
mm in breadth is required, and they should be protected by metal braids.
- For optical fiber cables, leave a 3 m length of cable for maintenance. Wind the
rest of the cable and store it near the GR4000. If an optical fiber cable and other
types of interface cables coexist, do not stress the optical fiber cable, since it
can break.
GR4000 Installation Guide Version 1.00 - Preliminary
99