Table of Contents
Advertisement
Choice of language
NOTE! The factory setting is English.
Available languages are:
Dansk
Deutsch
English
Español
Française
Nederlands
Italiano
Norsk
Suomi
Svenska
Eesti
Русский*
* The language is ordered as special
The following text appears in the display:
MENU SETTINGS
I
I
I
I
V
V
• Press STOP
and Increase value
seconds.
The following text appears in the display:
LANGUAGE
ENGLISH
•
Press Increase value
through the languages.
• Press START
to confirm the chosen language.
(SMB, SM6B) Smart = Boiling pan without agitator
(SMV, SM6V) Smart Variomix = Boiling pan with Variomix agitator
(SMP, SM6P) Smart Promix
(SVI, SV6I)
Smart Variomix ICE = Boiling pan with Variomix agitator and option ice water cooling
(SPI, SP6I)
Smart Promix
6
simultaneously for 3
or Decrease value
to browse
= Boiling pan with Promix
®
ICE = Boiling pan with Promix
®
Water filling of pressure vessel
Should be performed by trained personnel. (See Fig.1)
Before the pan is started up, the pressure vessel must be filled
with water (see also Operating Instructions).
Without option Automatic cooling
•
Press/turn Tilting
or
of approximately 45°.
•
Remove the plug on the rear of the pan and turn the knob
90°, (See Fig. 1 pos.20 in Installation instructions).
•
Fill water through the nipple up to the hole.
•
Press/turn Tilt return
the working position. Surplus water will run out until the
correct water level is achieved in the pan.
•
Turn back the knob and reinstall the plug.
Check that water or steam are not leaking when the vessel
reaches the working pressure.
With jacket cooling or ice water cooling
If the pan is equipped with comfort control, the water is filled
automatically by going into a hidden menu:
•
Press Menu forwards
for 5 seconds.
•
Enter code 1122 by pressing Increase value
value
for number, and Menu forwards
for location.
•
Confirm by pressing Start
•
Select SERVICE with Decrease value
forwards
(from Rev. UCP0419 push Menu forwards
3 times).
•
Fill the pressure vessel with water by pressing Increase value
.
•
Switch off the water with Decrease value
to run out of the tube under the pan.
•
Exit the hidden menu by pressing Control switch On/Off
.
Alternatively, the pressure vessel can be filled with water by
starting the COOLING program, see Operating Instructions.
The water level in the vessel should be checked at least once/
quarter.
Without option Level control:
If the pan is equipped with level control; the
vessel will be filled with water automatically to
the correct level when the boiling pan is ener-
gized.
Note
The boiling pan must be connected to the wa-
ter before the boiling pan be energized for the
first time.
agitator
®
agitator and option ice water cooling
®
and set the pan at an incline
or
and return the pan to
and Menu back
simultaneously
or Decrease
or Menu back
.
and press Menu
when it starts
Hide quick links:
Advertisement
Table of Contents
