Table of Contents
Advertisement
cleaning the drain filter
Be careful not to burn yourself while cleaning the drain filter. Water draining from
the filter compartment may be hot after a high temperature wash.
Before cleaning the drain filter, switch off and unplug the washing machine.
1. Open the service panel. Place a suitable container under the service panel to catch the water.
2. Carefully loosen the drain filter. Water may drain out - this is normal.
3. Unscrew the filter to remove it.
4. Remove any lint and debris before carefully replacing the filter.
5. Turn the filter clockwise to screw back into place. Close the service panel.
preventing a frozen water supply hose
If your washing machine is delivered in freezing weather conditions,
leave it at room temperature for 24 hours after you've set it up before
using it. This ensures there's no ice blocking the water supply hose. If
your water supply hose freezes, add 2 or 3 litres of warm water to the
drum. Then run a "Drain" only programme.
cleaning the filter net of the water supply hose
1. Turn the water supply off at the tap.
2. Close the washing machine door and select "Drain" programme and press the Start/Pause
button.
3. When finished, turn the power off. Remove the water supply hose from the tap.
4. Manually remove the filter net located on the tap side of the water supply hose and clean using
a small brush (e.g. a toothbrush).
5. Return the filter net to its original position.
6. Re-connect the water supply hose to the tap and turn the tap back on, checking for leaks.
22
about
50°C
Advertisement
Table of Contents
