8
http://www.home-comfort.com
Remote control
Note:
Turn on the power button on the device
before use.
Setting weekday and time
•
Press the
press the ▲ or ▼ key to select the day.
•
Press the
or – key to set the hour.
•
Press the
or – key to set the minute.
•
Press the
Setting temperature
Note:
This setting is only applicable for the
temperature in standard heating mode, not
for the temperature in the timer mode. The
default set temperature is 20
Note:
The heater only starts working when the
set temperature is higher than the room
temperature.
•
Press the + or – key to set the temperature,
which ranges from 15 to 30
•
After the temperature setting has been
completed, the display flashes about 5
seconds, then shows the room temperature.
SUN
key. When the day is flashing
SUN
key again, then press the +
SUN
key again, then press the +
key to confirm the setting
C.
o
C.
o
Setting fire sound
•
Up to 5 levels fire sound can be set.
▲
▼
•
Press the
or
key to increase or
decrease the fire sound levels EEC from
maximum to no fire sound. The LED display
will show the fire sound setting.
Setting timer
•
Up to 9 different timer settings can be
programmed.
•
Each timer setting has its day, power-on
time and power-off time.
•
The maximum duration of each timer
setting is 23 hours 50 minutes.
•
If the power-off time of the timer setting
fails on the following day, it is unnecessary
to set the day-just set the power-off time.
•
Press the
key, the timer number starts
blinking (P1-P9).
•
Press the + or – key to select a timer
number.
•
Press the
key, the cursor on the left
side of the day blinks.
•
Press the or key to move the cursor to the
corresponding day. Press the + key to add
a corresponding day, or press the - key to
delete a day.
•
Press the
key to set the on time. The
hour digit starts blinking.
•
Press the + or – key to set the hour.