Table of Contents
Advertisement
Figure 4
1. Bolt—1/2 x 4 inches (2)
2. Washer (2)
3. Left lower roll bar tubes
g222619
4. Locknut (1/2 inch)
5. Right lower roll bar
(installed)
4.
Loosely install the left and right support brackets
using 1 bolt (1/2 x 1-1/4 inches), 1 locknut (1/2
inch), 1 bolt (1/2 x 1-3/4 inches), and 1 washer
for each bracket
Note:
Ensure that the battery ground cable
routes under the right support bracket and other
cables route above the right support bracket
(Figure
6).
1. Right support bracket
(installed)
2. Bolt (1/2 x 1-3/4 inches)
3. Washer (2)
5
(Figure
5).
Figure 5
4. Left support bracket
5. Locknut (1/2 inch)
6. Bolt (1/2 x 1-1/4 inches)
g222622
Advertisement
Table of Contents
