Toro Sand Pro 5040 Operator's Manual page 19

8. Tighten both lift lever guide plate mounting
screws to secure the adjustment
9. Remove the hour meter from the old control
panel and install it in the new control panel.
10. Install the new control panel and plug the wire
into the hour meter.
11. Secure the control panel in place with the
fasteners previously removed
Figure 26
1. Knob
12. Install the knob onto the lift lever
13. Grease the front lift frame; refer to
Lift Frame (page
14. Check the hydraulic-fluid level and replenish the
fluid as required.
(Figure
(Figure 26).
2. Control panel
(Figure
Greasing the
20).
12
25).
Reading/Storing the
Documentation
Parts needed for this procedure:
1 Operator's Manual
Procedure
1. Read the documentation.
2. Store the documentation in a safe place.
g003676
26).
19