Mitsubishi Electric KD Series User Manual page 16

1-3-1 Conditions - CE mark certification – When using optional Power Supply Unit (PSU)
1. KD6R367CX (L1 type）
KD6R367CX
V1 Ａ
V2
Ｂ
D1◎
Ｃ
D2
Ｃ
D3
Ｃ
D4
Ｃ
1. KD6R367CX (L1 type）
TM-XH719C
1-3 CE marking
Optional
Ａ
PSU
Port 1
Port 2
Port 3
Port 4
Frame
Grabber board
Attach ferrite cores as described in below.
- Cable between V1 connector and 5V power supply: One Ferrite core A (2 turn)
- Cable between V2 connector and 24V power supply: One Ferrite core B (2 turn)
- Cables between Connectors D1-D4, and Frame grabber: One Ferrite core C for each cable (3 turn)
- Cable between PSU and 24V DC power supply: One ferrite core A (2 turn)
COPYRIGHT©2017-2020 MITSUBISHI ELECTRIC CORPORATION. ALL RIGHTS RESERVED.
DC24V power
In order to make this product complied with CE mark, attach ferrite cores on the
cables as shown on the left diagram. The ferrite cores enable to reduce the noise
emission from the cables.
Recommended ferrite cores are shown below.
Ferrite core A： RFC-20,
Ferrite core B： RFC-H13, KITAGAWA INDUSTRIES CO.,LTD
Ferrite core C： RFC-20,
KITAGAWA INDUSTRIES CO.,LTD
KITAGAWA INDUSTRIES CO.,LTD
16