Procedure For Tilting Up (Power Trim And Tilt Models) - Yamaha F225C1 Owner's Manual

Operation
ECM00991
NOTICE
Before tilting the outboard motor, follow
G
the procedure under "Stopping engine"
in this chapter. Never tilt the outboard
motor while the engine is running. Se-
vere damage from overheating can re-
sult.
To prevent the cooling water passages
G
from becoming frozen when the ambient
temperature is 5°C or below, tilt the out-
board motor up after it has been
stopped 30 seconds or more.
EMU32723
Procedure for tilting up (power trim
and tilt models)
1. Place the remote control lever in neutral.
2. Press the power trim and tilt switch "
(up) until the outboard motor has tilted up
completely.
UP
60
N
ZMU04588
ZMU04194
UP
3. Pull the tilt support lever toward you to
support the engine. WARNING! After
tilting the outboard motor, be sure to
support it with the tilt support knob or
tilt support lever. Otherwise the out-
board motor could fall back down sud-
denly if oil in the power trim and tilt
"
unit or in the power tilt unit loses pres-
sure.
[EWM00262]
tilt support lever or knob when traile-
ring the boat. The outboard motor
could shake loose from the tilt support
and fall. If the motor cannot be trail-
ered in the normal running position,
use an additional support device to
secure it in the tilt position. For more
detailed information, see page 64.
[ECM01641]
ZMU04602
NOTICE: Do not use the