Locate and have accessible the Site Log for recording information about this installation.
•
Tools and Parts
Use the following list of tools and parts as a checklist for preparing for installing the SCE 2000 platform:
Appropriate cables to connect the SCE 2000 to the network and console terminal
•
Tape measure (optional)
•
Level (optional)
•
•
Number 1 Phillips screwdriver
Number 2 Phillips screwdriver
•
1/4-inch flat-blade screwdriver
•
1/4-inch hex wrench
•
Grounding kit (shipped with SCE 2000)
•
12 AWG or 2.5 mm copper installation wire with hex or loop connectors for DC power leads (DC power only)
•
Ring terminals must be UL approved and suitable for 12 AWG wire.
AC power cords (AC power only, shipped with SCE 2000)
•
Rack-mounting kit (shipped with SCE 2000)
•
Spare screws for changing bracket position
•
Prepare for Rack-Mount Installation
Before you begin the rack-mounting tasks, determine the type of rack—four-post or two-post—that you will be using.
Workbench or Tabletop Installation
Figure 1: Installing the System on a Flat Surface
For a workbench or tabletop installation, verify the following before installing the SCE 2000 platform:
The SCE 2000 platform is off the floor and has adequate ventilation.
•
An adequate chassis ground (earth) connection exists for the SCE 2000 platform.
•
The SCE 2000 platform has at least 2 inches (5 cm) of clearance at each side and at least 5 inches (12.7 cm) of
•
clearance at the rear to allow proper air flow.
5