Table of Contents
Advertisement
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
The network configuration Main menu appears as follows:
Caution
At the prompt, enter N to configure default network port values and press Enter.
Step 7
At the Enter IP address for Interface No. 1 prompt, enter the IP address you want to assign to the
Step 8
Cisco Unified Videoconferencing 3515 MCU
Caution
Step 9
At the Enter Default Router IP Address prompt, enter the IP address of the router that you want the
Cisco Unified Videoconferencing 3515 MCU
Caution
At the Enter IP Mask (HEX) prompt, enter the subnet mask as follows:
Step 10
–
For example, for the subnet mask 255.255.255.0 the hexadecimal value you enter is FFFFFF00.
Note
–
After you enter the subnet mask parameter, the unit updates the boot line parameter and reboots.
At the network configuration Main menu, enter Q to save your changes and allow the device to complete
Step 11
the boot process.
Configuration of any of the parameters other than N: Configure default network port values may alter
Caution
the function of the device and should not be performed by an unauthorized person.
OL-11897-01
Press any key to start configuration...
Main menu
N: Configure default network port values
P: Change the configuration software password
S: Configure network security level
A: Advanced configuration menu
Q: Quit
Select:
If you do not press a key before the countdown ends, the device continues its initialization and
you can only configure the device by pressing the RST button on the front panel.
Do not use leading zeros in the IP address.
Do not use leading zeros in the IP address.
Convert the subnet mask IP address to hexadecimal notation, enter the hexadecimal number at
the prompt, and press Enter.
You can use the desktop calculator on your computer to convert the subnet mask ID to
hexadecimal notation.
If a subnet mask is not used, press Enter.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration
and press Enter.
unit
to use and press Enter.
unit
2-7
Advertisement
Table of Contents
