Canon iPF9000S Troubleshooting Manual page 27

Panel display
Code
(last 4
Large LCD
digits)
2015 Cannot cut paper.
Press Load/Eject
and reload the
paper.
Cannot cut paper.
Reload the paper.
Cannot cut paper.
Lift the release
lever and reload
the paper.
Paper cutting
failed. Lift the
release lever.
2016 No sheets.
Press Load/Eject
and reload the
paper.
No sheets.
Lift the release
lever and reload the
sheets.
The paper is too
small.
Check paper size.
Sheet removed.
Lift the release
lever.
Paper jam.
Press Load/Eject and
reload the
paper.
Paper jam.
Manually rewind roll
all the way.
Paper jam.
Manually rewind roll
all the way
and press OK.
Cannot feed paper
Lift the release
lever and reload
paper.
Cannot feed paper.
Reload the paper.
Cannot feed paper.
Press Load/Eject
and reload the
paper.
Small Small
LCD 1 LCD 2
Cutting Press Cutting failure/jam detected due to a cutting
↑ Key
Error failure
Please to An idle cutter unit or a cutter blade that is too
Cut Papr Release blunt to cut sheet has been detected by the
Paper paper leading edge detection sequence.
Sheets Paper loosened out of position while printing
Please Load The trailing edge of paper has been detected
Sheet Not Loaded at least 20 mm shorter than the length of cut
forms detected.
Paper Jam Jam while picking up, ejecting or printing on
Press ↑ Key
paper
(A sequence of removing jams with the pinch
roller released is required)
Virtually all recovery errors that could occur in
Paper Jam
Press ↑ Key
connection with paper pickup are handled.
Paper Eject Err
Remove Paper
Explanation/Detection sequence
2-15
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Go to ★2015
(P3-17).
Go to ★2F24
(P3-18).
Reload the paper.
Go to ★2E27
(P3-14).
①Open and
close the
release lever to
reload the
paper.
②Remove the
paper once
and then
refeed it.
★Go to 2E27
(P3-14)