Cisco AS5400XM Quick Start Manual page 53

The modem speed 115200 bps and hardware flow control are the default settings for integrated modems.
Note
To configure the lines and ports to allow users to dial in to your network, follow these steps:
Use the enable command and password to enter privileged EXEC mode. You are in privileged EXEC mode when the
Step 1
prompt changes to
Gateway> enable
Password: password
Gateway#
Enter global configuration mode. You are in global configuration mode when the prompt changes to
Step 2
Gateway# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Gateway(config)#
Specify the country for which to set parameters such as country code and encoding. This setting is applied at the system
Step 3
level. All feature cards use the same country code. The default is usa if the gateway is configured with T1 interfaces;
the default is e1-default if the gateway is configured with E1 interfaces. Use the no form of this command to set the
country code to the default of usa.
All sessions on all feature cards in all slots must be idle for this command to run.
Note
Gateway(config)# spe country country name
Enter the numbers of ports to configure. If you want to configure 108 ports on slot 3, enter line 3/00 3/107. If you
Step 4
want to configure 324 ports on slots 3 through 5, enter line 3/00 5/323.
Gateway(config)# line slot/port slot/port
Gateway(config-line)#
Allow all protocols to be used when connecting to the line:
Step 5
Gateway(config-line)# transport input all
Enable remote IP users running a PPP application to dial in, bypass the EXEC facility, and connect directly to the
Step 6
network:
Gateway(config-line)# autoselect ppp
Step 7 Enable incoming and outgoing calls:
Gateway(config-line)# modem inout
Step 8 Return to privileged EXEC mode:
Gateway(config-line)# Ctrl-Z
Gateway#
To save the gateway configuration, save it to NVRAM. See the "Saving Configuration Changes" section on page 60.
Tip
Verifying the SPE Configuration
To verify your SPE configuration, use the following commands:
• To display a summary for all the lines, enter the show spe command:
Gateway# show spe
.
Gateway#
Gateway(config)#.
53