HP iPAQ hw6510 Manual page 12

• Infrared
• GPRS/EDGE
To synchronize your personal computer and your HP iPAQ using
the cradle:
1. Be sure ActiveSync is installed on your personal computer. Refer to
"How Do I Install Microsoft ActiveSync?"
more information.
2. Connect the USB connector on the cradle 1 to the USB port on
your computer.
3. Connect one end of the AC Adapter 2 to the cradle and connect
the other end to an electrical outlet to charge the unit.
4. Insert the HP iPAQ in the cradle 3 and push firmly to seat it.
Synchronization begins automatically.
CAUTION: To avoid damaging your HP iPAQ or the cradle, check to be
sure the HP iPAQ and cradle connectors are properly aligned before
pushing the unit into the cradle.
To synchronize your personal computer and your HP iPAQ using the
autosync cable:
1. Be sure ActiveSync is installed on your personal computer. Refer to
"How Do I Install Microsoft ActiveSync?"
more information.
2. Plug the AC adapter into an electrical outlet, then connect the other
end of the AC adapter to the AC connector on the autosync cable.
3. Connect the 22-pin connector on the autosync cable to the universal
sync connector on the bottom of your HP iPAQ.
in this document for
in this document for
8