Table of Contents
Advertisement
global_main.book.book Page 13 Thursday, August 13, 2020 5:29 PM
• For your safety and for extended product life, use only authorized components. The manufacturer is not
responsible for product malfunction or accidents caused by the use of separately purchased
unauthorized components or parts.
Installation Place
Requirements
Before installing the appliance, check the following
information to make sure that the appliance
should be installed in a correct place.
Installation Location
• A grounded electrical outlet should be located
within 61 cm of either side of the appliance.
• Install the appliance on a flat floor. (Allowable
slope under the appliance: 1°)
• The floor must be level, with a maximum slope of
2.5 cm under the appliance. If the slope is
greater than 2.5 cm, the appliance cannot be
levelled properly.
• Ensure that when the appliance is installed, it is
easily accessible for an engineer in the event of a
breakdown.
• Do not install the appliance in an area where it
will be exposed to water and/or weather. Failure
to follow this warning could result in risk of
electric shock, injury, or product damage or
malfunction.
• Do not install the appliance on a hollow or
flexible platform. Doing so may cause excessive
noise and vibration and result in damage or
injury if the appliance tips over.
NOTE
• A sturdy floor should support the total appliance
weight of 78 kg. The combined weight of any
other laundry appliances should also be
considered.
INSTALLATION
Dimensions
A
B
C
D
E
F
G
Recommended Installation
Spacing
The following clearances are recommended for the
appliance. Although the appliance has been tested
for clearances of 3 cm on the sides and rear,
13
EN
Dimensions (mm)
385
1435
415
52
1850
445
585
Advertisement
Table of Contents
