Canon Pro9000 Mark II Service Manual page 4

Pro9000 Mark II
1. MAINTENANCE
1-1. Adjustment, Periodic Maintenance, Periodic Replacement Parts, and
Replacement Consumables by Service Engineer
(1) Adjustment
Adjustment
EEPROM
initialization
Destination
settings
(EEPROM
settings)
Ink absorber
counter resetting
(EEPROM
settings)
Ink absorber
counter value
setting
(EEPROM
settings)
Ink absorber
replacement
Paper feed motor
position
adjustment
Automatic print
head alignment
Grease
application
Timing
- At logic board replacement
- At logic board replacement
- At logic board replacement
- At ink absorber replacement
- At logic board replacement
- When the ink absorber becomes
full
- At paper feed motor replacement To adjust the belt tension.
- At print head replacement
- At logic board replacement
- When print quality is not
satisfying
- At carriage unit replacement
- At PR lift shaft replacement
- At other part replacement
TABLE OF CONTENTS
Purpose
To initialize settings
To set destination.
To reset the ink absorber
counter.
To set the ink amount
data in the ink absorber to
the ink absorber counter.
To replace the ink
absorber with a new one.
(Position the paper feed
motor so that the belt is
stretched tight.)
To secure the dot
placement accuracy.
To maintain sliding
properties of the carriage
shaft, PR lift shaft, other
sliding parts, and gears.
1 / 56
Approx.
Tool
time
*1
1 min.
Service Tool
Perform in the
service mode.
*1
1 min.
Service Tool
Perform in the
service mode.
*1
1 min.
Service Tool
Perform in the
service mode.
*1
1 min.
Service Tool
Perform in the
service mode.
Screwdriver, a 10 min.
pair of
tweezers, etc.
None. 5 min.
None. 5 min.
Perform in the
user mode.
- EU-1 1 min.
- FLOIL GP-
1000R
- MOLYKOTE
PG641
- FLOIL KG-
107A
- MOLYKOTE