Yamaha YZF-R1 Owner's Manual page 26

Instrument and control functions
1
2
3
1
4
1. Mode switch "MODE"
5
2. Up button
3. Center button
6
4. Down button
Right
7
8
9
10
11
1. Stop/Run/Start switch "
2. Wheel switch " "
12
Pass/LAP switch "
2
Press this switch to flash the headlights
3 and to mark the start of each lap when
using the lap timer.
4
Dimmer switch "
Set this switch to "
beam and to "
(See page 7-35.)
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
leased, the switch returns to the center
1
position. To cancel the turn signal
lights, push the switch in after it has re-
2
turned to the center position.
Horn switch "
Press this switch to sound the horn.
/ / "
Stop/Run/Start switch "
To crank the engine with the starter, set
this switch to "
EAU66091
/LAP"
EAU66021
/ "
" for the high
" for the low beam.
EAU66040
/ "
". To signal a left-hand
". When re-
EAU66030
"
EAU66060
/ / "
", and then push the
4-4
switch down towards " ". See page
6-1 for starting instructions prior to
starting the engine.
Set this switch to " " to stop the engine
in case of an emergency, such as when
the vehicle overturns or when the throt-
tle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
Mode switch "MODE"
Use the mode switch to change YRC
modes or edit the PWR, TCS, and SCS
EAU66010
" posi-
ECA10062
EAU66111