General Setup (General) - Sony DSX-M80 Help Manual

Help Guide
Marine Audio
DSX-M80

General Setup (GENERAL)

DEMO (demonstration)
Activates the demonstration: [ON], [OFF].
CLOCK (clock)
Sets the clock: [AUTO <RDS>], [MANUAL].
TUNING STEP (tuning step)
Sets the FM/AM tuning step of your country: [FM50K/AM9K], [FM100K/AM10K], [FM200K/AM10K].
(Available only while the source is off and the clock is displayed.)
DETACH ALERT (detach alert)
Activates the detach alert: [ON], [OFF].
The detach alert will sound for a few seconds if you turn the ignition switch to the OFF position without detaching the
front panel. The alarm will only sound if the built-in amplifier is used.
(Available only while the source is off and the clock is displayed.)
BEEP (beep)
Activates the beep sound: [ON], [OFF].
AUTO OFF (auto off)
Shuts off automatically after a certain time when the unit is turned off and the clock is displayed (i.e. press and hold OFF
for 1 second): [ENABLE] (30 minutes), [DISABLE].
SPEAKER LOAD (speaker impedance load)
Sets the impedance load of the speaker connection: [4 OHM] (4 Ω load connection), [2 OHM] (2 Ω load connection).
(Available only while the source is off and the clock is displayed.)
Set to [2 OHM] when connecting as follows:
- When connecting front speakers in parallel.
- When connecting subwoofer(s) to right and left rear speaker leads.
- When connecting a dual voice coil subwoofer with 4 Ω to 8 Ω impedance.
USB AUTOPLAY (USB auto play)
Activates the USB auto play: [ON], [OFF].
56