Honeywell Dolphin CT40HC User Manual page 88

9. Proceed to
Set Up Client Devices
The Wi-Fi Staging client runs automatically on the initial boot of a new device.
However, it must be started manually on existing devices.
New Devices
This section applies to new, out-of-the box devices only. For existing devices, see
the next section.
1. Set up a server device (see page 75).
2. Place the new devices to be configured within 1 meter (3 feet) of the server
Note: Client devices should be kept on the Android Welcome or setup wizard screen during
staging. If you finish the setup wizard manually the client side of Wi-Fi Staging will
stop running.
Configurations will be distributed to any client that connects to the server device.
Once the data transmission finishes successfully, the name and serial number of
the configured client will display in the Wi-Fi Staging app on the server device, and
the client device will skip the Android setup wizard.
Existing Devices
To start the Wi-Fi Staging client on an existing device:
1. Set up a server device (see page 75).
2. Turn on the client device and launch the Wi-Fi Staging app by tapping Settings
3. Tap To be Staged.
4. A message will display notifying you that the Wi-Fi settings on the client device
5. Place the device within 1 meter (3 feet) of the server device and it will begin
78
Wi-Fi Staging will start a hotspot on the server device and wait for clients to
connect.
Set Up Client Devices
device and turn them on.
When a new device boots up and begins the setup wizard, it will attempt to
retrieve configuration from the server device, and a staging progress screen will
display.
> Honeywell Settings > Wi-Fi Staging.
will be reset as part of the staging process. Tap OK to confirm you wish to
proceed.
Staging will begin and a progress screen will display.
searching the server hotspot for a configuration.
on page 78.
Dolphin CT40 Mobile Computer