Table of Contents
Advertisement
TROUBLESHOOTING
If you have any problems while using this product, please check the following point
first.
If a problem cannot be solved by taking actions described below, unplug the battery
charger and contact the dealer or an authorised TOSHIBA TEC service
representative for assistance.
Symptom
A battery pack is loaded in
the battery charger, but
the CHARGE lamp does
not light up in red.
The CHARGE lamp blinks
in red.
Charging time overruns
the approximate specified
time.
Battery pack does not last
long time though the
battery is fully charged.
The battery pack cannot
be inserted into the slot.
Cause and resolution
The power cord is not connected properly.
Firmly connect the power cord to the AC
adapter and the AC outlet.
The terminals of the battery charger or the battery
electrodes are stained.
Wipe clean those portions with a soft dry cloth.
You are attempting to charge a battery pack with the
over discharge protection activated (The CHARGE
lamp may not light up immediately after loading a
battery.)
Leave the battery charger and the battery pack
alone for a few minutes. If the CHARGE lamp does
not light after all, stop using the battery pack, as the
battery pack may be faulty.
The partition is not fitted.
Fit the partition in the correct orientation.
A battery pack failure is detected.
It could be the end of battery life. Replace the
battery pack with a new one.
Charging time varies depending on the condition of
the battery pack, ambient temperature, etc.
If the battery charger continues charging even
after the specified time has passed, stop
charging and replace the battery pack with a
new one.
It could be the end of battery life.
Replace the battery pack with a new one.
The partition is not set completely.
Fit the partition completely.
13
Advertisement
Table of Contents
