Table of Contents
Advertisement
4
Troubleshooting
Troubleshooting
Problem
Cause & Correction
y The power cord is not plugged in. Plug in the power cord.
y Check whether electricity failed. Check the condition by operating other
No Power.
y Check whether you select right function. Press FUNCTION and check the
No sound.
y The volume is set to minimum. Use the volume controller to adjust the
y An unplayable disc is inserted. Insert a playable disc.
y No disc is inserted. Insert a disc.
The unit does not start
y The disc is dirty. Clean the disc. (Refer to the page 17)
playback.
y The disc is inserted upside down. Place the disc with the label or printed side
y The antenna is positioned poorly. Adjust its position.
y The signal strength of the radio station is too weak. Tune to the station
Radio stations cannot
be tuned in properly.
y No stations have been preset or preset stations have been cleared (when
y The remote control is not pointed at the remote sensor of the unit. Point the
y The remote control is too far from the unit. Operate the remote control within
The remote control
y There is an obstacle in the path of the remote control and the unit. Remove
does not work properly.
y The battery in the remote control is exhausted. Replace the battery with new
electronic devices.
selected function.
volume.
facing upwards.
manually.
tuning by scanning preset channels). Preset some radio stations, see page
12 for details.
remote control at the remote sensor of the unit.
about 16 ft (5 m).
the obstacle.
one.
Troubleshooting
15
4
Advertisement
Table of Contents
