Fluff Clean
Special programmes
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol
(Fluff removal
7
cycle) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The
(Fluff removal
7
cycle) symbol goes out after the programme starts.
To run the Fluff Clean programme, proceed as follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to Fluff Clean.
Press the Start/Pause button.
You can also run the Fluff Clean programme at any time without
prompting from the appliance.
Rinse + Spin
:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page 15.
Empty + Spin
:
Drain the rinsing water following a programme with $ (Rinse stop)
→ page 15.
Turn the programme selector to Empty + Spin.
Set the spin speed to $ (Rinse stop).
Press the Start/Pause button.
or
Drain and spin at the desired spin speed:
Turn the programme selector to Empty + Spin.
Press the Spin rpm button repeatedly until the desired spin speed is
set.
Press the Start/Pause button.
14