DeWalt DW631K Instruction Manual page 22

E N G L I S H
Check for misalignment and seizure of moving
parts, breakage of parts and any other conditions
that may affect its operation. Have damaged
guards or other defective parts repaired or
replaced as instructed.
Do not use the tool if the switch is defective.
Have the switch replaced by an authorized
D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Additional safety rules for cutters
• Always use cutters with a shank diameter
corresponding to the size of the collet installed in
your tool.
• Always use cutters suitable for a speed of
30.000 min -1 and marked accordingly.
• Never use cutters with a diameter exceeding the
maximum diameter indicated in the technical data.
Package contents
The package contains:
1 Laminate trimmer
3 Collets (6 mm, 6.35 mm, 8 mm)
1 Wrench 17/19
1 Copy follower
2 Guide rods
1 Trimming plate
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your laminate trimmer DW631K has been designed
for trimming wood and plastic laminates.
1 On/off-switch
2 Depth stop adjuster
3 Plunge lock
4 Trimming base
5 Chip shield
en - 3
6 Motor clamping lever
7 Guide knob
8 Guide rods
9 Copy follower
10 Clamping knob for guide rods
11 Dust extraction spout
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or .
15