Before Use - Panasonic AJ-EC3P Operation Instructions Manual

Before use

The unit's functions may be restricted by the type of camera recorder used. Before use, therefore,
check the camera recorder model and the functions which can be used with it.
Model
AJ- D910WA
D610WA
AJ- HDC20A
BS900
AJ- D810
D700A
D700
D400
<Note>
Consult your dealer if a model not listed in the above table is going to be used.
Mode 1 All the unit's functions can be used. However, any old versions of
the software must be upgraded so consult your dealer about this.
Mode 2 Video signals cannot be output from the unit.
All the unit's other functions can be used.
Mode 3 1. No VTR operations (START/STOP, FF, REW, STOP and PLAY
REC CHECK) can be performed.
2. The GAMMA, KNEE SLOPE, KNEE POINT and DETAIL
controls cannot be operated.
3. The shutter speed is set to 1/60 or 1/100 when S.S. or S.V is
selected by the SHUTTER selector switch.
4. The FILTER settings cannot be displayed.
Only GAIN or IRIS can be selected for LED display using the
CHECK button.
5. The SETUP menus are not the unit's menus. The camera
recorder's menus are output from the camera recorder's VIDEO
OUT connector. Menus are not output to the unit's VIDEO OUT
connector.
6. Only L, M or H can be selected by the GAIN selector switch,
and these settings appear as 0, 9 and 18 on the LED display.
7. PAINTING is enabled at all times.
Functions which can be used
E-3