Preparing For Use; Baby Unit; Operation On Non-Rechargeable Batteries - Philips AVENT SCD535/70 Manual

- Do not expose the baby unit and parent unit to extreme cold or heat or to direct sunlight. Do
not put the baby unit and the parent unit close to a heating source.
- Never place the baby unit inside the baby's bed or playpen.
- Never cover the parent unit and the baby unit with anything (e.g. a towel or blanket). Always
make sure the cooling vents of the baby unit are free.
- If you place the parent unit next to a transmitter or other DECT appliance (e.g. a DECT
telephone or wireless router for the internet), the connection with the baby unit may be lost.
Move the baby monitor further away from the other wireless appliances until the connection is
restored.
- Switched-on mobile phones in the vicinity of the baby monitor may cause interference with the
baby monitor.
- Radio interference is inevitable and may have an effect on the sound quality of the baby monitor.
- This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult
supervision and should not be used as such.
- Take every precaution to make sure that your baby can sleep safely .
- The humidity and temperature sensor only measures the temperature and humidity in the baby
room. It cannot be used to control or adjust the temperature and humidity in the baby room.
- This monitor is not intended to be used as a medical monitor and its use should not replace
adult supervision.

preparing for use

Baby unit

You can use the baby unit corded or on non-rechargeable batteries. Even if you are going to use the
unit corded, we advise you to insert non-rechargeable batteries. This guarantees automatic back-up
in case of power failure.
Corded operation
1 Put the large appliance plug in the baby unit and put the adapter in a wall outlet (Fig. 4).

operation on non-rechargeable batteries

The baby unit runs on four 1.5V R6 AA batteries (not included). We advise you to use Philips LR6
PowerLIfe batteries or an equivalent type.
Do not use rechargeable batteries, as the baby unit does not have a charging function.
Place batteries in the baby unit if you do not want to use it corded or if you want to be sure of
backup power in case of power failure. Replace the batteries when the baby unit indicates that the
batteries are low (the empty battery symbol flashes on the display and the text 'Battery low'
appears).
Unplug the baby unit and make sure your hands and the unit are dry when you insert the
non-rechargeable batteries.
1 Remove the lid of the compartment for non-rechargeable batteries (Fig. 5).
2 Insert four non-rechargeable batteries (Fig. 6).
Note: Make sure the + and - poles of the batteries point in the right direction.
3 Reattach the lid (Fig. 7).
Note: When the batteries are low, the battery light on the baby unit flashes red.
EngliSh
11