Panasonic AK-HRP1005GJ Operating Instructions Manual page 123

Setting of the CCU or ROP takes about 2 minutes to complete after you click the [Save] button. If the AC adaptor or LAN cable is
disconnected before the settings are completed, the settings will be canceled. In such a case, configure the settings again.
Even though the network settings have been completed, the network operations is not performed properly if the same IP address
is used by another device on the same network. Set the IP address that does not coincide with an existing IP address.
Do not configure the network settings from multiple instances of Easy IP Setup Software at the same time.
NOTE
Set the network settings for the CCU from the menus of the CCU. (For details, refer the operating instructions for the CCU.) Restart
the CCU after changing of the settings is complete.
Firewall
If a firewall (including software) exists, allow access to UDP for all ports.
If a firewall is activated, enable the "Allow a program through Windows Firewall" setting.
1. Open the control panel, and click [System and Security].
2. Click [Allow a program through Windows Firewall] of [Windows Firewall].
3. Select the [Internet Explorer] or [EasyIpSetup] line, click the [Change settings] button, and then add a
check to [Internet Explorer] or [EasyIpSetup].
4. Click [OK].
- 123 -
Software