Certification Information - Epson SS-300 User Manual

Chapter 12
Troubleshooting

12-5 Certification information

Japan
* Except for model SS-300
USA
FCC ID: BKMAP001
WristableGPS
Model: SS-300/SS-500/SS-700
FCC NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
Properly shielded and grounded cables and connectors must be used for connection to host computers and / or
peripherals in order to meet FCC emission limits.
Use a genuine USB cable with a ferrite core.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled equipment and meets the
FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment has very low levels of RF
energy that are deemed to comply without testing of specific absorption ratio (SAR).
All EPSON products with the ANT+ logo have been certified as interoperable by ANT+. For more information, visit
www.thisisant.com/directory
In case you purchases further HR sensors, we recommend using optional EPSON products.
*Except for model SS-300
138
Model: SS-300/SS-500/SS-700