Installation Procedure - Kenwood LZ-612IR Instruction Manual

Accesaries/Installation Procedure
Accessories
①
②
③
④
Remote Control Cable ..........1
⑤
⑥
⑦
⑧
Mounting Screw (Ø4x16) ..........2
8
|
LZ-612IR
DC Cord ..........1
Monitor Cable ..........2
RCA Cable ..........2
Template ..........1
Mounting Bracket ..........2
Removal Tool ..........1

Installation Procedure

1. To prevent short circuits, remove the key from the
ignition and disconnect the
battery.
2. Make the proper input and output cable
connections for each unit.
3. Connect the wiring harness wires in the following
order: ground, ignition.
4. Connect the wiring harness connector to the unit.
5. Install the unit in your car.
6. Reconnect the terminal of the battery.
7. Press the reset button. (page 2)
WARNING
• This product is intended for use with 12V DC negative
ground power only. Do not connect it to any other power
supply.
• To prevent shorting, disconnect the battery cable from the
negative terminal of the battery during installation.
• Be sure to firmly stabilise this product. Do not install it in a
location which is not stable.
• Follow the installation and wiring procedures described in
this manual. Improper wiring or modified installation can
not only result in malfunction or damage to the unit but
may also result in an accident.
• Mounting and wiring this product requires skills and
experience. For safety's sake, leave the mounting and wiring
work to professionals.
• If your car's ignition does not come with an ACC position,
connect the ignition wires to a power source that can be
turned on and off with the ignition key. If you connect the
ignition wire to a power source that receives a constant
voltage supply, as with battery wires, the battery may die.
• If the fuse blows, first make sure that the wires have not
caused a short circuit, then replace the old fuse with one
with the same rating.
• Do not let unconnected wires or terminals touch metal
on the car or anything else conducting electricity. To
prevent short circuits do not remove the caps from unused
terminals or from the ends of the unconnected wires.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• Insulate unconnected wires with vinyl tape or other similar
material.
• Thoroughly wipe away oil and other dirt from the
installation surface.
Please avoid installation on uneven surfaces.
• Do not install the Hideaway Unit under the carpet.
Otherwise heat build-up occurs and the unit may be
damaged.
terminal of the