Table of Contents
Advertisement
Name
NO.
Def.
A B
Valid
6
Mult-
4
All
(*)
Sensor
Function
Switch
0
0
1
0
0
0
Description
Multisensor function switch. Using bit
to control.
Bit0: Disable magnetic integrate
illumination to turn ON the lighting
nodes in the association group 2.
(1:Disable, 0:Enable)
Bit1: Disable PIR integrate
Illumination to turn ON the lighting
nodes in the association group 2.
(1:Disable, 0:Enable)
Bit2: Disable magnetic integrate PIR
to turn ON the lighting nodes in the
association group 2. (1:Disable,
0:Enable) (Default is Disable)
Bit3: When Bit2 is 0 (Enable), Are the
device and the lighting in the same
room?
0: In the same room(Default),
1: In the different room.
Notice: If this bit is 1, it is
recommended also set the Bit1 to 1,
cause
the PIR triggered, doesn't
mean the people in that room.
Bit4: Disable delay 5 seconds to turn
off the light, when door/window
closed. (1:Disable, 0:Enable)
Bit5: Disable auto turn off the light,
after door/window opened to turn on
the light. (1:Disable, 0:Enable)
Notice: If bit2 is zero, this setting is
0
0
Name
NO.
Def.
Valid
Name
NO.
Def.
Valid
7
Customer
4
All
(*)
Function
0
0
1
0
0
0
0
10
useless.
Notice: If the configuration No.9 is
zero, this setting is useless.
Bit6: Reserve.
Bit7: Reserve.
Description
A B
Description
A B
Customer function switch, using bit
control.
Bit0: Reserve.
Bit1: Enable sending motion OFF
report. (0:Disable, 1:Enable)
Note: Depends on the Bit4,
0: Report Notification CC,
Type: 0x07, Event: 0xFE
1: Sensor Binary Report,
Type: 0x0C, Value: 0x00
Bit2: Enable PIR super sensitivity
mode. (0:Disable, 1:Enable)
Bit3: Disable send out BASIC OFF
after door closed. (1:Disable,
0:Enable)
Bit4: Notification Type,
0: Using Notification Report.
1: Using Sensor Binary Report.
Bit5: Disable Multi CC in auto report.
(1:Disable, 0:Enable)
Bit6: Disable to report battery state
when the device triggered. (1:Disable,
Advertisement
Table of Contents
