Yamaha 02R Owner's Manual page 283

The I/O cards fall into three groups:
• Digital I/O Cards – These cards provide 8 tracks of digital input and
output. They are used to connect the 02R to a digital multitrack
recorder – either tape or disk based. Cards supporting ADAT, TDIF-1,
YAMAHA, and AES/EBU formats are available. Except for the
CD8-AE card, these cards are single slot, allowing you to insert up to
four cards giving you a maximum 32 tracks of digital mixdown.
• Analog I/O Card – This card provides 8 tracks of analog input and
output. It can be used to connect the 02R to an analog multitrack
recorder or to expand the analog inputs and outputs of the mixer.
Conversion is performed in 20-bit linear. The sampling frequency is the
same as the current wordclock master on the 02R.
• Cascade I/O Card – This card allows you to connect the bus lines 1
through 8, two pairs of the auxiliary buses 1 through 8 to the cascade
card's AUX A and AUX B buses, the STEREO bus, and the SOLO bus
of two or more 02R's. One 02R is the cascade master, the others are
slaves.
The following table lists the I/O cards available:
Card Format
AES/EBU
Digital I/O ADAT
TDIF-1
YAMAHA
Analog I/O AD/DA
Cascade Kit
Peak Meter Bridge
The Peak Meter Bridge (MB02) displays the levels for all the input, output,
and bus channels of the 02R, plus it duplicates the stereo output signal
levels. The meter bridge duplicates the information shown in the METER
display function in a much more convenient form.
Installing Options
Product Size & Location
double – slots 1 or 2
CD8-AE
(max 2 cards – 16 ch)
single – all slots 1 through 4
CD8-AE-S
(max 4 cards – 32 ch)
single – all slots 1 through 4
CD8-AT
(max 4 cards – 32 ch)
single – all slots 1 through 4
CD8-TD
(max 4 cards – 32 ch)
single – all slots 1 through 4
CD8-Y
(max 4 cards – 32 ch)
double – slots 1 or 2
CD8-AD
(max 2 cards – 16 ch)
single – kit incl. 2 cards & con-
CD8-CS necting cable. slots 1 through 4
(normally 3 or 4)
Digital Recording Console 02R User's Guide
173