Download Print this page
Kenwood TTM404 Instructions
Kenwood TTM404 Instructions

Kenwood TTM404 Instructions

Advertisement

Quick Links

before using your Kenwood
experience and knowledge, unless
appliance
they have been given supervision or
Read these instructions carefully
instruction concerning use of the
and retain for future reference.
appliance by a person responsible
Remove all packaging and any
for their safety.
labels.
Children should be supervised to
ensure that they do not play with
safety
the appliance.
Only use the appliance for its
Burnt food can catch fire, so:
intended domestic use. Kenwood
● ●
never leave your toaster on
will not accept any liability if the
unattended;
appliance is subject to improper
● ●
keep your toaster away from
use, or failure to comply with these
anything (eg curtains) that could
instructions.
catch fire;
before plugging in
● ●
set the browning control lower for
Make sure your electricity supply is
thin or dry bread;
the same as the one shown on the
● ●
never warm food with a topping or
underside of your toaster.
filling (eg pizza): if it drips into the
toaster, it could catch fire.
This toaster complies with
European Economic Community
● ●
Clean the crumb tray regularly:
crumbs can smoke or burn.
Directive 89/336/EEC.
To avoid electric shocks, never:
Important – UK only
● ●
let the toaster, cord or plug get wet;
The wires in the cord are coloured
or
as follows:
● ●
put your hand or anything metal,
Green and Yellow = Earth,
eg a knife or foil, into the toaster.
Blue = Neutral,
Always unplug the toaster when not
Brown = Live.
in use, before cleaning or
The appliance must be protected
attempting to clear jammed bread.
by a 13A approved (BS1362) fuse.
Never cover your toaster with a
WARNING: THIS APPLIANCE
plate or anything else - it could
MUST BE EARTHED.
overheat and catch fire.
Never let the cord hang down
Note:
where a child could grab it.
For non-rewireable plugs the fuse
We recommend that you do not
cover MUST be refitted when
use your toaster directly under wall
replacing the fuse. If the fuse cover
cupboards.
is lost then the plug must not be
Do not move the toaster whilst it is
used until a replacement can be
in operation.
obtained. The correct fuse cover is
Never touch hot surfaces especially
identified by colour and a
the metal top area.
replacement may be obtained from
Never use an unauthorised
your Kenwood Authorised Repairer
attachment or accessory.
(see Service).
Never use a damaged toaster. Get it
If a non-rewireable plug is cut off it
checked or repaired: see 'Service'.
must be DESTROYED
This appliance is not intended for
IMMEDIATELY. An electric shock
use by persons (including children)
hazard may arise if an unwanted
with reduced physical, sensory or
non-rewireable plug is inadvertently
mental capabilities, or lack of
inserted into a 13A socket outlet.
before using for the first time
hints on using your
1 Clip excess cord into the cord
toaster
storage clips in the base
.
Operate the toaster once on a
Select a lower setting for light
medium setting without bread. (The
browning, for toasting one slice only
lever will not stay down unless the
or for dry bread.
toaster is plugged in).
When toasting a single slice of
As with all new heating elements,
bread, you may notice a variation in
your toaster may emit a slight
toast colour from one side to the
burning smell when it is first
other - this is normal.
switched on. This is normal and not
Dry/stale bread toasts more quickly
a cause for concern.
than fresh bread and thinly sliced
bread toasts more quickly than
key
thickly sliced bread. Therefore the
browning control should be set at a
lever(s) (with 'Hi-Rise™' for extra
lower setting than usual.
lift)
For best results ensure that the
browning control(s)
bread slices are of an even
cancel button with indicator light(s)
thickness, freshness and size.
defrost button with indicator light(s)
In order to achieve uniform
reheat button with indicator light(s)
browning we recommend you wait
crumb tray(s)
a minimum of 30 seconds between
cord storage
each toasting so that the control
can automatically reset. Alternatively
to use your toaster
select a lower setting when
1 Move the browning control to the
additional toasting is carried out.
desired setting. Use a low setting
For best results larger slices
for light toasting and for thin or dry
of bread are best positioned
bread.
long ways in the slot.
2 Insert the bread, muffins, bagels
care and cleaning
etc.
3 Lower the lever
until it locks.
1 Before cleaning, unplug your
(The lever will not stay down unless
toaster and let it cool down.
the toaster is plugged in). The
2 Slide out the crumb tray
cancel button light will come on.
then replace. Do this regularly:
To toast frozen bread, once the
crumbs can smoke or even burn.
bread is lowered press the 'defrost'
3 Wipe the outside of the toaster with
button, its light will come on.
a damp cloth, then dry.
To warm toast that's popped up but
gone cold, lower the toast then
press the 'reheat' button. Its light
will come on.
To stop toasting at any stage, press
the 'cancel' button. Never lift the
lever to cancel toasting.
4 Your toast will pop up automatically.
To raise it higher, lift the lever.
. Clean,

Advertisement

loading

Summary of Contents for Kenwood TTM404

  • Page 1 Kenwood experience and knowledge, unless before using for the first time hints on using your appliance they have been given supervision or 1 Clip excess cord into the cord toaster ● Read these instructions carefully instruction concerning use of the storage clips in the base ●...
  • Page 2 ● you supply your receipt to show when you bought it. This guarantee does not affect your statutory rights. TTM402 TTM404 Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK www.kenwoodworld.com 18253/2...

This manual is also suitable for:

Ttm402