Kenwood NEXEDGE NX-200S Instruction Manual page 14

INSTALLING THE BELT CLIP
Attach the belt clip using the
Note: If the belt clip is not
installed, its mounting location
may get hot during continuous
a hot environment.
glues, may crack the transceiver's back panel.
INSTALLING THE CAP OVER THE UNIVERSAL CONNECTOR
Insert the cap into place over the
universal connector and secure
it in place using the attached
INSTALLING THE (OPTIONAL) SPEAKER/ MICROPHONE OR
HEADSET
1 Insert the guide of the
headset connector into place
over the universal connector.
2 Secure the connector in place
Note: When not using an optional
install the cap over the universal
connector.
Belt clip
3 x 8 mm screws
Universal
connector cap
Optional
speaker/ microphone