Table of Contents
Advertisement
Philips Sound Solutions
3.3.4.5.1 AC3/DTS Pass-Through
Sonic Edge passes AC3 or DTS digital audio data from a DVD to S/PDIF OUT. This feature allows
you to play a DVD on your PC using a soft-DVD player, utilizing an external AC3/DTS decoder.
Examples of an external decoder are receivers, speaker sets with built in AC3 decoder, or a stand-
alone AC3 decoder boxes. AC3 is available when using a compatible soft-DVD player capable of
streaming AC3 or DTS data to the soundcard. To enable AC3/DTS Pass-Through, you must select
Digital Output (S/PDIF) in the Setup Tab.
3.3.4.6. Preamp Slider
The Preamp Level control allows you to boost the audio signal before it passes through the
amplification circuitry. To the outside world it has the same effect as the master volume has.
Caution: If you notice any distortion in the sound, lower the Preamp Slider level to eliminate the
distortion.
3.3.4.7. Fader Slider
Fader controls the balance between the front and the rear speakers.
3.3.4.8. Center Slider
Center controls the level of output on the center speaker only. Use this slider to adjust the volume on
the center speaker.
3.3.4.9. LFE Slider
This slider provides control for the volume level of the subwoofer.
3.3.4.10. Balance Slider
This slider allows you to balance the left and the right speakers. It affects the front and the rear
speakers.
3.3.4.11. Test Button
The Test button opens a window, which allows you test your speakers one by one. Testing a
speaker channel enables you to ensure that the speakers or headphones are properly connected.
The test utility displays a button for each of the possible output channels, but the number of active
buttons depends on your selected output mode. Click any active speaker button to send the test
sound to the corresponding speaker. See Figure 15.
The "Loop Sounds" button allows you to repeat the test sound until you click Stop. If the Loop
Sounds is off, the sound will only play once for each click of a speaker button.
The Auto button sends the test sound to each speaker once and moves it to the next speaker
automatically.
The Close button exits the test utility and returns you to the Main Control Panel Setup Tab.
Sonic Edge™ Soundcard User's Guide
22
Advertisement
Table of Contents
