Advertisement
Available languages
Available languages
Operation
Check Parameter
After backlight is lit, hold
temperature display area. The indoor unit NO. will be displayed 0 to F ( hexadecimal) at the bottom
right of the parameter value. LED light dot quantity from 1 to 6 matches parameter category from A
to F. Press
to switch indoor unit NO. and switch parameter by
parameter checking interface, it will exit automatically or press swing to exit.
The definition of A, b, C, d, E, F is shown as the following table:
Parameter category
A
b
C
d
E
F
Address searching and setting
After backlight is lit, hold
Communication address will show in temperature display area and indoor unit NO.( 0-F) will display at
the bottom right of parameter. Press
blinking, press
or
Wireless signal receiving
The wired controller is able to receive wireless signal. When receiving the correct command, the
buzzer will sound once. When receiving an illegal command, the buzzer will sound three times.
and
for 5s to check parameter. The parameter value will show in
Definition
Temperature from indoor unit sensor Tai
Temperature from indoor unit sensor Tc1
Temperature from indoor unit sensor Tc2
Indoor unit PMV opening/2
indoor unit address
Indoor unit central control address
and
for 5s to enter into address searching and setting interface.
to switch indoor unit NO. When communication address is
to adjust. Press
Counting method
to confirm changes.
11
or
. If untouched for 10s in
decimal
decimal
decimal
hexadecimal
hexadecimal
hexadecimal
Advertisement
