Installing An Inverter - Huawei SUN2000 Series User Manual

SUN2000-(12KTL-25KTL)-M5 Series
User Manual
● Move the inverter with care to prevent device damage and personal injury.
● Do not hold the wiring terminals and ports at the bottom. Do not place the
● When you need to temporally place the inverter on the ground, use protection
----End

4.5 Installing an Inverter

Installation Precautions
Avoid drilling holes into the water pipes or power cables buried in the wall.
● To avoid inhaling dust and to prevent dust from falling into your eyes, ensure
● Use a vacuum cleaner to clean up dust in and around the holes, and measure
● Level the top of the expansion sleeve with the concrete wall after removing the
● Loosen the nuts, flat washers, and spring washers of the two expansion bolts
Issue 01 (2022-06-15)
CA UTION
inverter with the wiring terminals and ports touching the ground or other
supporting surface.
material such as foam and paper underneath to prevent damage to its
enclosure.
D ANGER
NO TICE
that safety goggles and a dust mask are worn when drilling holes.
the spacing. If the holes are inaccurately positioned, drill the holes again.
bolt, spring washer, and flat washer. Otherwise, the mounting bracket will not
be securely installed on the concrete wall.
below.
NO TE
● M6x60 expansion bolts are delivered with the inverter. If the length and quantity of the
bolts do not meet installation requirements, prepare M6 stainless steel expansion bolts
by yourself.
● The expansion bolts delivered with the inverter are mainly used for solid concrete walls.
For other types of walls, prepare bolts by yourself and ensure that the wall meets the
load bearing requirements of the inverter.
● For support-mounting, prepare M6 stainless bolt assemblies (including flat washers,
spring washers, and M6 bolts) with appropriate lengths as well as corresponding flat
washers and nuts based on the support specifications.
Copyright © Huawei Digital Power Technologies Co., Ltd.
4 Installation
21