Mitsubishi Electric MELSEC Q Series User Manual page 113

5 UTILITY PACKAGE (GX Configurator-TC)
Function
Auto refresh setting
Monitor/test
5 - 2
Downloaded from ManualsNet.com
(1) The temperature control module buffer memory is configured for automatic refresh channel-by-
channel.
• Write Data Error Code
• CH Temperature Process Value(PV)
• CH Manipulated Value (MV)
• CH Set Value (SV) Setting
• CH Transistor Output Flag
• CH Alert Definition
• CH Alert Set Value1
• CH Alert Set Value2
• CH Alert Set Value3
(2) Values set for auto refresh and stored in the temperature control module buffer memory are
automatically read out when the END instruction is executed in the programmable controller
CPU.
The buffer memory of the temperature control module and I/O signals are monitored or tested.
The auto tuning function is also available.
• Write Data Error Code
• CH Decimal Point Position
• CH Temperature Process Value(PV)
• CH Manipulated Value (MV)
• CH Set Value (SV) Setting
• CH Transistor Output Flag
• CH ON Delay Output
• Q64TCTT(BW) Cold Junction Temperature
Process Value
• X00:Module Ready Flag
• X01:Operation Mode Status
• X02:Write Error Flag
• X03:Hardware Error Flag
• X04:CH1 Auto Tuning Status
• X05:CH2 Auto Tuning Status
• X06:CH3 Auto Tuning Status
• X07:CH4 Auto Tuning Status
2
• X08:E PROM Write Completion Flag
• X09: Default Value Write Completion Flag
2
• X0A:E PROM Write Failure Flag
• X0B:Setting Change Completion Flag
• X0C:CH1 Alert Occurrence Flag
• X0D:CH2 Alert Occurrence Flag
• X0E:CH3 Alert Occurrence Flag
• X0F:CH4 Alert Occurrence Flag
• Y01:Operation Mode Command
• Y02:Error Reset Command
• Y04:CH1 Auto Tuning Command
• Y05:CH2 Auto Tuning Command
• Y06:CH3 Auto Tuning Command
• Y07:CH4 Auto Tuning Command
2
• Y08:E PROM Backup Start Command
• Y09:Default Setting Registration Start
Command
• Y0B:Setting Change Command
• Y0C:CH1 Forced PID Control Stop
Command
search engine
Description
• CH Alert Set Value4
• CH Proportional Band (P) Setting
• CH Integral Time(I) Setting
• CH Derivative Time(D) Setting
• CH Loop Disconnection Detection
Judgement Time
• CT Heater Disconnection Alert Setting
• CT Heater Current Process Value
• CH Manipulated Value
• CH Temperature Rise Judgment Flag
• CH Alert1
• CH Alert2
• CH Alert3
• CH Alert4
• CH Heater Disconnection Alert
• CH Loop Disconnection Alert
• CH Output Off-time Current Error Alert
• CH Alert1 Mode Setting
• CH Alert Set Value1
• CH Alert2 Mode Setting
• CH Alert Set Value2
• CH Alert3 Mode Setting
• CH Alert Set Value3
• CH Alert4 Mode Setting
• CH Alert Set Value4
• Alert Dead Band Setting
• Alert Delay Count
• CH Loop Disconnection Detection
Judgment Time
• CH Loop Disconnection Detection Dead
Band
• CH Heater Disconnection Alert Setting
• Heater Disconnection/Output Off-time
Current Error Detection Delay Count
• Heater Disconnection Compensation
Function Selection
• CT Monitor Method Switching
• CT Heater Current Process Value
• CT Channel Assignment Setting
• CT CT Selection
• CT Reference Heater Current Value
• CH Manipulated Value
• Manipulated Value Resolution Switching
• CH Temperature Rise Judgment Flag
• Temperature Rise Completion Range
Setting
• Temperature Rise Completion Soak Time
Setting
MELSEC-Q
Reference
section
Section 5.5
5
Section 5.6
5 - 2