Configuration Hipath Hg 1500; Configuring The Ngk 100 Gatekeeper - Siemens Hicom 150 H Service Manual

For internal use only

3.2.1 Configuration HiPath HG 1500

Step
1. Under Voice Clients -> Gatekeeper:
Enter the IP address of the PC with the gatekeeper,
enable gatekeeper support and configure the prefix.
2. Under Voice Clients -> H.323 Clients:
Configure the clients with a gatekeeper connection using IP address
"255.255.255.255".
Clients without a gatekeeper connection must be configured with the fixed
IP addresses of the corresponding PCs.
3. Under Voice Clients -> Xpress Clients:
There are no additional aspects to be noted here.

3.2.2 Configuring the NGK 100 gatekeeper

Relevant options under "Settings"
Step
1. Capacity Characteristics:
Set the IRQ interval to 0 if the registered endpoints do not need to be cy-
clically polled, e.g. when using RAS connections for teleworking.
2. Call and Registration Policy:
Accept Call must be enabled.
Set All Endpoints or Predefined endpoints.
3. Routing Mode:
Set Gatekeeper Routed or Direct Routed.
A31003-K5020-S100-6-7620
Service Manual
Initial startup of HiPath HG 1500
Task
Task
lan2de.c03
Startup
3-5