Sony GeoSnap Airpeak S1 Integration Manual page 2

2. Position the GeoSnap antenna mount to align with the 4 holes and then screw in the
four 25mm long M3 screws with washers until they are tight.
Note: There is thread locker pre-applied on the screws so be sure not to confuse the
resistance from the thread locker with the screws being fully tight.
3. To raise the antenna mast, you must first loosen the thumb screw, rotate the mast to
the vertical position, then tighten the thumb screw again.
Note: It is normal to feel/hear a click when loosening the thumb screw. This is due to the
specialty lock washers disengaging.
Need help? Email support@fieldofviewllc.com or call 701-203-3757 x3
2