Kenmore 625.343920 Owner's Manual page 6

STEP 3 - ASSEMBLE AND
INSTALL FAUCET
Note: If the faucet is not assembled, slide the lever
over the cylindrical nut. Then, push or turn the
spout into the faucet body.
1. Standard Faucet, FIG. 4A:
A. Slide the chrome washer, large rubber washer
and lock washer, in that order, onto the faucet
stud.
B. Put a few wraps of Teflon tape on the end of
the faucet stud. Using the washer, turn the tubing
adaptor onto the faucet stud and tighten securely.
C. On the underside of the sink or countertop, in
sert the large steel washer between the lock
washer and the bottom of the sink or countertop.
Then, tighten the hex nut securely.
D. Insert the faucet stud through the mounting
hole.
2. Electronic Base Faucet, FIG. 4B:
A. Slide the small rubber washer and electronic
indicator base onto the faucet stud. Turn on and
tighten the hex nut, but do not overtighten and
break the base.
B. Put a few wraps of Teflon tape on the end of
the faucet stud. Using the washer, turn the tubing
adaptor onto the faucet stud and tighten securely.
C. Looking at FIG. 4C, locate the faucet support
and gasket over the sink or countertop mounting
hole. (First, break out the small button and save
for use in step G below.)
D. Turn the special nuts (FIG. 4D) a few turns
onto the 1-3/8" long screws.
E. Place a screw into a notch in the faucet sup
port, with the special nut on the underside of the
mounting hole (FIG. 4E). Use a finger to hold the
nut while tightening the screw until snug. Repeat
with the remaining screw and special nut. Be sure
the support is positioned correctly, then tighten
both screws evenly so the support is held firmly
in place.
F. Insert the faucet stud and base leadwire
through the support and mounting hole.
G. Lower the faucet and base down onto the sup
port, being careful not to pinch the leadwire. Use
the 5/8" long screw to fasten the faucet base and
support together. Insert the button (from step C)
into the hole to cover the screw.
All manuals and user guides at all-guides.com
INSTALLATION STEPS
6
FIG. 4
A
MODEL 625.343920
spout
lever
faucet
chrome washer
rubber washer
(large)
steel washer
(large)
lock washer
hex nut
washer
tubing adaptor
É É
compression
nut
É É
C
gasket
plumbers
putty
D
screw (2)
nut (2)
faucet
support
B
DELUXE
MODEL 625.343950
spout
lever
faucet
screw
rubber washer
electronic faucet
base
hex nut
washer
tubing adaptor
É É
compression
nut
button (use
in step 2G)
faucet
É É É É É É É É
support
mounting
hole
E
TOP VIEW
mounting
screw (2)
hole
nut (2) - under
side of mount
ing hole