Installation and removal
5.3 Wall mounting
4. Insert the device with the screwed-in head screws into the four key-hole brackets of
the mounting plate
key-hole brackets.
5. Pull the inserted device down
6. Secure the device to the holding plate on the side with two screws
torque is 1.8 Nm.
7. Connect the power supply, refer to the section "Power supply (Page 63)".
8. Fit the antennas, refer to the section "Antennas (Page 67)".
48
. Make sure that the head screws are correctly positioned in the
until it sits firmly in the key-hole brackets.
Operating Instructions, 03/2022, C79000-G8976-C484-05
. The tightening
SCALANCE W1788-x / W1748-1