Canon FINISHER - D1 Service Manual page 95

3) Remove the two screws each [4], and de-
tach the foot cover (front, rear) [3].
4) Release the machine from the copier. (See
I.C.)
D.2 If the copier is higher,
1) Loosen the fixing nut by turning it in the
direction of arrow C. Turn the caster ad-
justing foot in the direction of arrow D. A
full turn of the foot will change the height
by about 1.75 mm. Turn the foot as many
time as necessary. Perform this for the four
feet.
D.3 If the machine is higher,
1) Loosen the fixing nut by turning it in the
direction of arrow C. Turn the caster ad-
justing foot in the direction of E. A full turn
of the adjusting foot will change the height
by about 1.75 mm. Turn the foot as many
times as necessary. Perform this for the
four feet.
COPYRIGHT © 1999 CANON INC. CANON FINISHER - D1 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 MECHANICAL SYSTEM
[3]
[4]
Figure 3-115
C
Fixing nut
Figure 3-116
C
E
Fixing nut
Figure 3-117
[3]
[4]
D
Adjusting foot
Adjusting foot
3-7