Table of Contents
Advertisement
4.7.3 Connecting charging cables
NOTE
Pay attention not to reverse polarity. Connection with reversed polarity causes severe
damage to the battery pack.
1. Feed a pair of charging cables through each of
the large grommets and then through each of
the large cable entries.
2. Connect the charging cables to the terminal
block.
a) Remove the terminal cover plate, which is
placed over the terminal block to protect it.
b) Connect the negative cable (−) to the
terminal on the left and the positive cable
(+) to the one on the right. Tighten the
hexsocket screws to a torque of 6 N·m.
c) Place the cover back on top.
3. Push the grommets into the cable entries.
Battery Pack Installation
27
Advertisement
Table of Contents
