Advertisement
Available languages
Available languages
Assembly
1
Remove the side covers from the moniter.
Side
cover
2
Attach the legs to the bottom of base frames using the
screws D (4×16 mm).
Screw D
Leg
3
Loosen the two of the four screws at the rear of the
BKM-15R. Be sure to loosen the lower two.
4
Attach the stay to the rear of the BKM-15R.
(Set the upper two screws in the two holes of the stay.
Hook the two slits of the stay to the lower two screws
loosened in Step 3, and then tighten these screws.)
Stay
10
Assembly
Monitor
Base frame
BKM-15R
5
Attach the two base frames to the stay using the screws
C (4×8 mm).
Side
cover
6
Connect the supplied connecting cable to the DC 5V
IN and LAN(10/100) connectors at the rear of the
BKM-15R.
Note
Be sure to plug the female connector of the cable into the
DC 5V IN connector on the BKM-15R.
Plug the female
connector into
the BKM-15R.
7
Attach the two cable holders to the base frame and
extend the connecting cable through them.
Screw C
Advertisement
