Advertisement
16 www.electrolux.com
Occurrence
Dehumidifier is
operating, but
room is not dry
enough.
Frost appears on
coils above water
tank.
Abnormal noise.
"dF" code shows
on the display,
the compressor
stop running and
the dehumidifier
works at MAX fan
speed.
Possible Cause
Humidity setting is
too high.
Dehumidifier has
been installed or
restarted recently.
Dehumidifier does
not have sufficient
clearance to
operate.
Room temperature
is too low.
Refer to causes under "The programme / cycle lasts too long.".
Dehumidifier has
been turned on
recently.
Room Temperature
is too low.
The floor is not flat.
Room Temperature
is low, the
dehumidifier enters
in Defrost function
automatically.
Solution
Select Dehum function, and adjust
in manual mode to a lower setting or
choose Continunous operation for
maximum dryness.
The higher the moisture in the room air,
the longer it takes for the room air to
become dry.
Air flow to air intake is blocked. See "4.1
Selecting a Location".
Unit will not operate satisfactorily if the
room temperature is below 5°C (41°F).
See "4.2 How it Works".
This is normal due to refrigerant rushing
through the coil. Frost will usually
disappear within 60 minutes.
Please operate dehumidifier when room
temperature is above 5°C (41°F).
Please install the dehumidifier on level
floor.
This is normal, the dehumidifier will
automatically quit Defrost function after
some minutes and continue working with
current operating setting.
Advertisement
