Service Note - Sony DSC-WX50 Service Manual

Ver. 1.2 2012.03
The changed portions from
Ver. 1.1 are shown in blue.
1-1. PRECAUTION ON REPLACING THE SY-311/SY-321 BOARD
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the "DESTINATION DATA WRITE".
RESTORE DATA
When you replace to the repairing board, get the data from the former one.
Start the Adjust Manual in the Adjust Station and perform "RESTORE DATA" to get the data.
The data getting for this model is as follows.
• USB SERIAL No.
• Angular Velocity Sensor Sensitivity adjustment
• AWB standard data input & check, Color reproduction check
• Strobe adjustment
Regarding the PlayMemories Home
PlayMemories Home has been written in internal memory.
SY-311/SY-321 board for service is supplied with written the
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Start the Adjust Manual in the Adjust Station and execute the "USB SERIAL No. INPUT".
Angular Velocity Sensor
When you replace to the repairing board, write down the sensitivity displayed on the angular velocity sensor (SE401/SE1401).
Start the Adjust Manual in the Adjust Station and execute the "Angular velocity sensor sensitivity adj".
SY-311/SY-321 BOARD (SIDE A)
SE401/SE1401
Type A:
P
P: PITCH sensor sensitivity
Y: YAW sensor sensitivity
Type B:
Note: The sensor sensitivity of SE401/SE1401 of SY-311/SY-321 board is written only repair parts.
DSC-WX50_L2
PlayMemories Home.
Y

1. SERVICE NOTE

1-2. ADDITION OF DESTINATION DATA FILE
If the Destination Data file included in the Adjust manual is old, "DESTINATION DATA WRITE" cannot be executed in some cases.
In that case, download a new Destination Data file from the TISS homepage according to the following procedure.
Note 1: To perform Destination Data Write for this model, the Adjust manual of the DSC-WX50 series must have been installed.
Install the Adjust manual of the DSC-WX50 series in advance.
Note 2: The actual image may differ from the image shown above.
1) If the Destination Data file in the Adjust manual in use is old, the window shown in Fig. 1 is displayed.
Click the [OK] button.
2) The Destination Data Write window opens.
Check the version of the Destination Data file retained in the Adjust manual.
1-1
Fig. 1
Destination Ver. window
– ENGLISH –