Troubleshooting; Specifications - Panasonic DH-3PL1 Operating Instructions Manual

4. TROUBLESHOOTING

(1) Check the following points before asking for repair.
Symptom
Water is not drawn normally. 1. Check the Filter Unit. Clean the Filter if it is clogged by stain and dirt (refer Filter Unit Cleaning at page 6).
2. Check the Shower Head and Shower Plate. Clean the Shower Head and Shower
No hot water comes out from 1. Make sure the Main Switch Knob is at "On" position.
the outlet 2. Make sure the ELB Reset Lever is not slide down.
(no electric supply to the unit)
3. Make sure to switch on the ON/OFF DP (double pole) Switch.
4. Make sure to switch on the Miniature Circuit Breaker (MCB).
No water flows out from the 1. Check the Water Volume Knob. Turn the Water Volume Knob clockwise if it is closed.
Shower Head at all. 2. Check the Main Water Valve. Turn "ON" the Main Water Valve if it is closed (refer to HOW TO USE at page 5).
Water not hot enough. 1. Check the WATER FLOW RATE ADJUSTMENT as in page 5.
(2) If abnormalities as mentioned below are found during use, please do not use the Unit and contact your authorized dealer
immediately.
1) Water leakage.
2) No water flow.
3) Water temperature cannot be controlled.
4) ELB lamp does not light up.
(3) Special skill is required for repairing. Never try to repair the Unit by yourself.

5. SPECIFICATIONS

Model No
Voltage
Electric Power Control
Min. Water Pressure
Max. Water Pressure
Dimension
Weight
Outlet System
Plate if it is clogged by dirt (refer Shower Head Cleaning at page 6).
Push up the ELB Reset Lever to reset the ELB (refer to TEST OPERATION at page 11).
DH-3PL1
Inlet Water Temp. (Off), 1000 W ~ 3500 W
295(H) mm X 154(W) mm X 82(D) mm
Single Point System (Open Outlet)
- 7 -
Points to be checked
220 V a.c. 50 Hz
Inlet Water Temp. (Off), 1000 W ~ 4500 W
9.8 kPa / 0.1 kgf/cm² / 1.42 psi
380 kPa / 3.87 kgf/cm² / 55 psi
1.2 kg
DH-4PL1