Advertisement
CX-961
- How to remove the loading arm assy and
spindle motor
Spindle
Loading Arm Assy
Motor
1. Remove the E ring of the left fulcrum and remove
the springs and loading arm assy.
2. Remove the connector of the spindle motor and
remove the mounting three screws.
- How to remove the loading motor assy
Gear Cover
1. Remove the gear cover screw and remove the gear
cover.
2. Remove the holder which was tightened together
with the gear cover.
Holder
(Note):
At assembly, tighten the holder together with the gear
Holder
cover by approaching the holder to the arrow view
Leaf Spring
direction and touching the tip of the motor shaft.
Grease Application
At this time, screwing with the holder being pressed
tight causes higher motor load (this may cause a
Loading Motor Assy
malfunction), therefore tighten screws with the hand off
from the holder, having the holder touching to the
motor spindle edge.
3. Remove the solder of the motor lead wire.
4. Remove the leaf spring screw and remove the holder
and leaf spring.
5. Put the mechanical unit face downward, remove the
mounting screws of the loading motor assy and remove
the loading motor assy.
18
Advertisement
