INSTALLING THE STACK BRACKET KIT
1. Remove the Dryer
A. Carefully lay the dryer on its side .
B. Use an open-end wrench or pliers
Back out and remove
all 4 leveling legs
2. Install Rubber Pads
Locate the 4 rubber pads in the parts
package . Remove the adhesive backing
and firmly place over on the bracket
where you removed the leveling legs .
3. Install Bracket
A. Align the holes in the left bracket
B. Repeat the above step with the right
C. Set the dryer upright .
Leveling Legs
Use the packing material so you
don't scratch the finish on the dryer .
to remove the dryer leveling legs .
to Dryer Base
to Dryer
with the holes in the bottom left
corner of the dryer . Use a Phillips
screwdriver to install the 2 #12 x 1"
tapping screws .
bracket on the bottom right corner
of the dryer .
GEAppliances.com
NOTE: Make sure to set the dryer
on a piece of packing material so
the brackets that are attached to
the bottom of the dryer do not damage
the floor .
21